Advertisement
Quick Links
Advertisement
Related Manuals for Zanussi Z 52/6 W
Summary of Contents for Zanussi Z 52/6 W
- Page 1 REFRIGERATOR- FREEZER Z 52/6 W INSTRUCTION BOOKLET...
- Page 3 Before use Setting the temperature Freezing fresh food Storage of frozen food Thawing Making ice cubes Fresh food refrigeration Movable shelves Freezing calendar Internal cleaning External cleaning When the appliance is not in use Changing the light bulb Defrosting Positioning Shelf holders Rear spacers 2222 181-63...
- Page 4 - Thermostat control for both compartments - Dairy compartment - Can storage shelf - Bottle storage shelf - Salad crisper - Glass shelf - Storage shelves - Frozen food storage - Ice trays - Shelf for freezing fresh foods...
- Page 5 Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). The temperature inside the refrigerator is regulated by a thermostat with 6 temperature positions and one «OFF» (O) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat dial to the required position.
- Page 6 Frozen food, prior to being used, can be thawed in the fridge or at room temperature depending on the time available. Small food items may even be cooked from frozen; in this case cooking will take longer. Any frozen food which is allowed to thaw accidentally should either be eaten as soon as possible or thrown away.
- Page 7 The walls of the refrigerator have runners so that shelves can be positioned as desired. To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To do this proceed as shown in the diagram: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
- Page 8 • You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate/evaporator. • When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor.
- Page 9 Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption.
- Page 10 Remember to wash the defrost cleaner in hot soapy water at regular intervals. Dry throughly before replacing. When the frost has reached a thickness of up to 4mm it can be removed using a plastic scraper. During this operation it is not necessary to disconnect the appliance from the mains and remove the food.
- Page 11 If the appliance is not working correctly, please carry out the following checks before calling out an engineer. No power to the appliance The light does not come on The temperature in the fridge or freezer section is too high The freezer door will not open The compressor runs continously Excessive frost and ice has built up...
- Page 12 In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:- Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
- Page 13 DIMENSIONS POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY * GROSS CAPACITY NET CAPACITY This figure is based on standard test results in accordance with European Standard EN 153. Actual consumption will depend on how the appliance is used and where it is located. Height Width Depth...
- Page 14 IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the...
- Page 15 The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre. This appliance complies with the following E.E.C. Directives: (Low Voltage Directive) and subsequent modifications;...
- Page 16 The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance. Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in Fig. Then turn them through 45°...