Installation - Zanussi ZCM 700 X Instruction Booklet

Installation

IMPORTANT
This cooker must be installed by qualified
personnel to the relevant British Standards.
Any gas installation must be carried out by
a registered CORGI installer.
The manufacturer will not accept liability,
should the above instructions or any of the
other safety instructions incorporated in
this book be ignored.
Connecting to Gas
This cooker is designed to be installed with an
appliance flexible connection. Connection is made to
the RC 1/2 (1/2" B.S.P.) threaded entry pipe located
just below the hotplate level on the rear right-hand
side of the cooker.
A second entry pipe is located on the rear left-hand
side and it is locked by a security nut. Should this
second entry pipe allow a safer gas connection,
remove the security nut and the relevant gasket from
the left-hand entry pipe and place it onto the main
entry pipe, ensuring the gasket is correctly positioned
and the nut is well secured.
When the final connection has been made, it
is essential that a thorough leak test is
carried out on the cooker and installation.
Ensure that the main connection pipe does
not exert any strain on the cooker.
Note:
For certain types of gas bayonet connection used, it
may not be possible for the appliance to be pushed
fully back to the wall stops.
Important:
Flexible tubing MUST comply with BS.669 Current
Edition.
FO 0264
A) End of shaft with nut
B) Washer
C) Elbow
27