Table of Contents
Advertisement
After unpacking the appliance, check for any transport damage. Do not install the appliance if it has been damaged.
In the event of problems, contact Whirlpool Customer Service. To prevent any damage, only remove the appliance
from its polystyrene foam packaging at the time of installation.
• Packing materials (plastic bags, polystyrene, etc.) must be kept out of children's reach, as they are potentially
dangerous.
•
•
• Connect the power and switch on the motor and lighting system to check the operation.
•
Parts supplied:
a.
Plastic collar x 1pc
b . Warranty card x 1pc and Instruction manual x 1pc
c. Installation Accessories Set x 1 set
( M4 x 8 screw x 2 pcs + 3/16 x 5/8 washer head screws x 4 pcs + 3/16 x 40mm screw x 4 pcs+ #6 x 1"
wooden screw x 8pcs)
(AKTT600/IX: Upper installation brackets x 2 pcs + Lower installation brackets x 2 pcs)
1. Location
•
Suggest to close window door before using hood .(FIG. 1)
• The smoke has to rise up to 25 mm from cook top in order to reach hood's
2. Position
• The installation height is measured vertically from center of aluminum
• The min height is 650mm and the max installation height is 750mm for
gas hob.(FIG. 2)
• Avoid left-right or front-dropped inclination.(FIG. 3)
3. Exhaust duct
"
• 6 diameter exhaust duct is recommended to use in order to maximize
.
suc
• Before installing the hood, please apply fast drying glue to the collar and
securely attach it to the top of cooker hood's vent lid. Install the cooker
hood and exhaust duct to the plastic collar and seal with fast drying glue.
B
U
efore
sing he
I
nstallation
/
0
T
H
ood
.
3
(
FIG.1
)
(
FIG.2
)
(
FIG.3
)
Advertisement
Table of Contents
