Table of Contents
Advertisement
1-5-5. ISR
The following messages can be sent from the BKPF-206 so as to monitor the operation state of BKPF-
206 by installing the BKPF-206 in a digital video interface unit (PFV-D20/D100A/D200A/D300)
together with optional ISR (Interactive Status Reporting) interface board BKPF-500.
(For more details, refer to the Operation and Maintenance Manual of BKPF-500.)
Status message (Warning/error information)
Message
Description
NO INPUT
Indicates that no signal is input to the SDI IN connector or that signal input format is not
correct.
NO OUTPUT
Indicates that no signal is output to the SDI OUT connector.
NO AUDIO 1/2CH
Indicates that 1/2 CH audio signal is not multiplexed with the input SDI signal.
NO AUDIO 3/4CH
Indicates that 3/4 CH audio signal is not multiplexed with the input SDI signal.
AUDIO ERROR
Indicates that abnormality is found in the audio signal detected from an SDI signal.
+/_12 V DOWN
Indicates that +12 V or _12 V power is not supplied normally.
AUDIO PLL UNLOCK
Indicates that audio clock is not in synchronization with an SDI signal.
Setup message
Message
Status
SDI MODE
D1
D2
525/625
525
625
AUDIO GROUP
GROUP 1
SELECT
GROUP 2
GROUP 3
GROUP 4
EMPHASIS 1/2CH
ON
OFF
EMPHASIS 3/4CH
ON
OFF
AES/EBU
ON
1/2CH TO 3/4CH
OFF
BKPF-105A/205/205R
BKPF-106A/206/206R
Description
Indicates the setting state of a D1/D2 system select switch (S202-1).
Indicates the state of the video system that was discriminated and set by the
input SDI signal.
Indicates the audio group selected by setting audio group select switches (S202-
2 and S202-3).
Indicates the emphasis state of the 1/2 CH audio signal detected from an SDI
signal.
Indicates the emphasis state of the 3/4 CH audio signal detected from an SDI
signal.
Indicates whether a 1/2 CH audio signal is copied to a 3/4 CH audio signal by
setting a 3/4 OPE switch (S202-4).
1-5 .Information of BKPF-206
1-21(E)
Advertisement
Table of Contents
