Isr - Sony BKPF-105A Installation Manual

1-3-5. ISR

The following messages can be sent from the BKPF-106A so as to monitor the operation state of BKPF-
106A by installing the BKPF-106A in a digital video interface unit (PFV-D20/D100A/D200A/D300)
together with optional ISR (Interactive Status Reporting) interface board BKPF-500.
(For more details, refer to the Operation and Maintenance Manual of BKPF-500.)
Status message (Warning/error information)
Message Description
NO INPUT Indicates that no signal is input to the SDI IN connector or that signal input format is not
correct.
NO OUTPUT Indicates that no SDI signal is output to the SDI OUT connector or that no digital audio
signal is output to the AES/EBU OUT connector.
NO AUDIO 1/2CH Indicates that 1/2 CH audio signal is not multiplexed with the input SDI signal.
NO AUDIO 3/4CH Indicates that 3/4 CH audio signal is not multiplexed with the input SDI signal.
AUDIO ERROR Indicates that abnormality is found in the audio signal detected from an SDI signal.
AUDIO PLL UNLOCK Indicates that audio clock is not in synchronization with an SDI signal.
Setup message
Message Status
SDI MODE D1
D2
525/625 525
625
AUDIO GROUP GROUP 1
SELECT GROUP 2
GROUP 3
GROUP 4
AES/EBU ON
1/2CH TO 3/4CH OFF
BKPF-105A/205/205R
BKPF-106A/206/206R
Description
Indicates the setting state of a D1/D2 system select switch (S202-1).
Indicates the state of the video system that was discriminated and set by the input
SDI signal.
Indicates the audio group selected by setting audio group select switches (S202-2
and S202-3).
Indicates whether a 1/2 CH audio signal is copied to a 3/4 CH audio signal by setting
a 3/4 OPE switch (S202-4).
1-3. Information of BKPF-106A
1-11(E)