Building The Appliance In Under A Worktop - Zanussi ZU 9120 F Instruction Booklet

Building the appliance in under a
worktop
The dimensions of the recessed installation area
must correspond with those indicated in the figure.
S.I.004
The appliance could be inserted between two units
(a) or as an end unit (b).
If the appliance is to be installed between two units
with a matching furniture door/support panel, the
door/panel must be fitted to the adjacent unit using
suitable hinges (not supplied) before the appliance is
installed.
UPPER
SUPER.
D326
1. Fasten the side panel to the rear of the appliance
with the fixing brackets.
2. Fasten the appliance to the worktop or the sides,
a
b
3. The appliance is equipped with adjustable support
LOWER
INFER.
4. Separate parts A, B, C, D as shown in the figure.
15
UPPER
SUPER.
E
D319
applying the sealing strip between the refrigerator
and adjacent cabinet using the fixing brackets (E).
S.I.006
feet. To adapt the appliance to the height of the
installation area (max 870 mm), screw in, or screw
out the feet situated at each bottom corner.
PR266
LOWER
INFER.
E
B
A
C
D