Care And Cleaning - Zanussi ZTBB 276 User Manual

STARTUITSTEL (DELAY START)
With the STARTUITSTEL (DELAY
START) button, you can delay the
start of a programme by 3, 6 or 9 hours.
1. Select the programme and additional func-
tions.
2. Press the STARTUITSTEL (DELAY START)
button as many times as necessary (the
lights show which delay time have been
chosen).
3. To activate the delay timer, press button 4 -
START / PAUZE (START PAUSE) . The
lights 9h 6h 3h (lights 7, 8, 9) change on
every three hours until the time is getting on
for start cycle.
Starting the programme
Press the START / PAUZE (START PAUSE)
button. The programme is started.
The programme phase is shown by appropriate
lights; light 10 - DROGEN (DRYING) , light
11 - ANTI-KREUK / EINDE (END) .
Changing programme
To change a programme which has been selec-
ted by mistake once the programme has started,
first turn the programme selector to "O" - OFF
position. The programme is cancelled.
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob or if an
function button (excluding the ZOEMER (BUZ-
6)
ZER) button ) is pressed, led on the START /

Care and cleaning

Cleaning fluff filter
The filter collect all the fluff which accumulates
during drying. To ensure that the dryer works
perfectly, the fluff filter must be cleaned after ev-
ery drying cycle.
The warning light FILTER , is on to remind you
this operation.
6) Only dryers with buzzer button
www.zanussi.com
PAUZE (START PAUSE) button starts flashing
temporarily in red. The drying programme is not
however affected by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the lights
ANTI-KREUK / EINDE (END) and light 6 -
FILTER are on. If the buzzer is active, an acous-
tic signal sounds intermittently for about one mi-
nute.
The drying cycles are automatically fol-
lowed by an anti-crease phase which lasts
around 30 minutes. The drum rotates at inter-
vals during this phase. This keeps the laundry
loose and free of creases. The laundry can be
removed at any time during the anti-crease
phase. (The laundry should be taken out to-
wards the end of the anti-crease phase at the
latest to prevent creases from forming.)
1. Open door.
2. Remove laundry.
3. Remove filter after clothes has been re-
moved. Clean the filter.
Warning! Before You place the filter ,
please check it there is nothing inside the
filter seat.
4. Turn the programme selector to "O" (OFF) .
Important! Clean the filter after each drying cy-
cle.
5. Close the door.
Caution! Never operate the dryer without
fluff filter or with damaged or blocked fluff
filter.
41