Zanussi ZKT 652 DX Installation And Operating Instructions Manual page 44

Problem
Display is switching be-
tween two heat settings
is lit
is lit
and number are dis-
played
If you are unable to remedy the problem by following the above sug-
gestions, please contact your local Service Force Centre.
1
Warning! Repairs to the appliance are only to be carried out by qualified
service engineers. Considerable danger to the user may result from improp-
er repairs.
3
If the appliance has been operated incorrectly, the visit from the service
technician or dealer may not take place free of charge, even during the war-
ranty period.
44
Possible cause
Power management is
reducing the power of
this cooking zone
Unsuitable cookware
No cookware on the
cooking zone
Diameter of the base of
the cookware is too
small for the cooking
zone
Overheating protection
for the cooking zone
has been triggered
Safety cut-out has
been triggered
Electronics fault
Remedy
See the section
"Switching the power
function on and off"
Use suitable cookware
Put cookware on zone
Move to smaller cook-
ing zone
Use suitable cookware
Switch off the cooking
zone. Switch the cook-
ing zone on again
Switch off the cooking
zone. Switch the cook-
ing zone on again
Disconnect the appli-
ance from the electrical
supply for a few min-
utes (Take the fuse out
of the house's wiring
system)
If after switching on
again, is displayed
again, call the customer
service department