When Replacing Hotplate Burner Parts - Zanussi ZCGHL55X Instruction Booklet

Clean the burner crowns by soaking them in very hot soapy water. You
can remove any stubborn stains by scouring with a soap filled pad such
as 'Brillo'. If you look after the burner crowns in this way they will stay
reasonably clean. However the surface will dull with time.
Aluminium based saucepans can leave shiny metal marks on the
pan supports. Clean the pan supports regularly to remove the marks
using a mild abrasive like 'Cif' with a soft scourer. For more stubborn
marks you can use a soap filled pad such as 'Brillo'.
After cleaning the appliance parts, dry them
thoroughly before you put them back.

When replacing hotplate burner parts

1. Crown to body (Do not try to force the
crown on to the body). Make sure that the
hole in the crown is over the electrode.
Check that the two longer location pegs
sit in the slots in the body. When the
crown is in this position let it fall freely on
to the body. Check that the crown can be
moved slightly from side, to side.
2. Cap to crown
Place cap centrally on the top of crown
(enamel side up). Move sideways and
front to back to check the cap is properly
fitted.
3. Check for ignition
If a burner will not light then you need to check the crown and cap
positions.
The grill
Do not clean the grill burner itself.
The burner is designed to be self cleaning. Cleaning the grill may cause
the holes in the burner to become blocked preventing it from operating
correctly.
Please note that due to the nature of stainless steel the grill burner may
tarnish through use over a period of time. This is quite normal and is not
a fault on the appliance.
Clean the area around the grill frequently using hot soapy water.
After use you can soak the pan for a few minutes and then clean it
using mild abrasives or a soap filled pad such as 'Brillo'.
Clean the shelf using hot soapy water. Mild abrasives can be used
if necessary.
Z C G H L 5 5 X
28