Operating Sequence - Zanussi ZDC 5375 W Instruction Booklet

Operating Sequence

Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not
get caught between the door and filter.
5. Turn the selector dial to the desired programme to
switch the appliance on. To switch the appliance
off turn it to «Reset/Off».
Switching on the appliance for the first time.
Language
When switching on the appliance for the first time
you must set the language in which you want the
indicators on the display to appear.
Important!
If the display is not showing any language, the
appliance has already been switched on once. In
such case, go to the chapter «Change language» if
you would like to change the language setting.
Example:
Press the «Change» button until the desired
language appears in the display.
Press the EXIT button to confirm the selection.
All indicators on the display will appear in this
language from now on.
Note:
If the undesired language has been set, press the
«Spin and Option» buttons simultaneously for
about 3 seconds in order to change the language.
Follow the instructions as before.
Setting the time
You should set the time prior to the first drying
cycle and when changing to and from daylight
savings time. See «Clock setting», Menu.
6. Turn the selector dial, in order to select the
desired programme. The relevant message will
appear in the display.
The display will show the end cycle time «Cycle
end at» of the selected programme, calculated on
the basis of the maximum load for each type of
fabric. The START/PAUSE button light will start
flashing.
If the load of laundry to be dried is small, at the
beginning of the cycle the display will still
indicate the end cycle relevant to the maximum
load.
12