Specifications; Efx Send / Return; Rear Panel; Output Jacks - YORKVILLE BASS MASTER 400 User Manual

EFX Send / Return

FRONT
The signal at the EFX SEND jack is used to feed an
external effects device. The EFX RTN jack, when
used, disconnects the original signal going to the
power amplifier as well as the Line Output, the
signal is replaced with the signal from the EFX RTN
jack. Together, both jacks form the effects loop. The
effects loop Level is 1Vrms.

REAR PANEL

The rear panel effects-loop is post front panel effects
Power
The red LED above the power switch will light when
the BASS MASTER 400 is ON.

Output Jacks

Two parallel power amplifier output jacks are located
on the back panel. The minimum impedance of the
external speaker load is 4 Ohms. The power
amplifier is electronically and thermally protected
against unsafe loads. If the thermal protection
activates, reset will occur when the heatsink has
slightly cooled.
Input 0dB
Effects Return
DC Offset
Hum and Noise
loop. The phone plug ring is EFX SEND and the tip is
EFX RTN, the sleeve is ground.

Specifications

Power
> 725W, 4 Ohm load
1kHz, 2 cycle burst 750W typical
> 400W, 4 Ohm load
1kHz, continuous at 5%THD 440W typical
>300W, 8 Ohm load
1kHz, continuous at 5%THD 315W typical
*
Measurements made with regulated 120V supply
Sensitivity
< 25mVrms
< 1Vrms
750mVrms typical
< 60mV
15mV typical
> -90dB below max output voltage, unweighted
-94dB typical
* Measurements made with GAIN and VOLUME at 5, CONTOUR and EQ off .
.