Kenwood XD Series Instruction Manual page 31

Selection of the reverse mode
Each press sw itches the modes as follow s.
1 "[" ... Both sides are played back (recorded), and
then the tape stops.
2 """ .. Both sides are played back endlessly.
(The tape stops after recording onto both
sides.)
3 """ .. Only one side is played back (recorded),
and then the tape stops.
Select an input source other than "TAPE".
REC/ ARM
To pause recording
REC/ ARM
Downloaded from: http://www.usersmanualguide.com/
REV.M ODE
4 . Select the source to be recorded.
1 TUNER (Radio)
2 CD
4 4
3 TAPE
4 AUX (External input)
(AUX INPUT LEVEL adjustment
5 . Start recording.
1 Play (or tune) the input source to be
recorded.
2 Start recording.
5 5
÷ Recording stops automatically w hen the tape
side(s) to be recorded have been fully recorded.
÷ The beat cancel function can be used w hen
recording M W broadcasts.
÷ Pressing the key pauses recording after leaving a non-recorded space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes
from that instant.
Selection of DOLBY NR
The Dolby NR system minimizes the hiss noise heard w hen
playing tape. When playing a tape prerecorded w ith Dolby
NR ON, be sure to set the DOLBY NR ON for playback.
DOLBY NR
Each press sw itches the modes as follow s.
1 "1 NR" ON ............. DOLBY NR is used.
2 "1 NR" OFF ............ DOLBY NR is not used.
The input source component to be recorded should be displayed.
C
o
)
÷ When the CD input is selected and if a disc has
been set in the CD player, its playback starts
immediately.
C
¤
Let's record
XD-SERIES (En)
(Noise Reduction)
Lit w hen "DOLBY NR" is ON.
T A P E B 0
NR
D 0 1 0 0 0
1 2 3
D 0 1 0 1 2
1 2 3
Lights
31