Kenwood CT Series Instruction Manual page 17

4
Start recording.
CT-2050/ KXF-W6010
CT-203/ KXF-W4010
Bias level adjustment (Deck B of the CT-2050/KXF-W 6010 only)
The M ODE key can be used to adjust the bias level.
How to use the M PX FILTER key
Use this function w hen recording a radio (FM ) broadcasts.
Downloaded from: http://www.usersmanualguide.com/
1
Press the REC/ ARM (¶) key.
¶
REC/ARM
Press once.
2
Play the music source from the begin-
ning.
1
Press the M ODE key and select the "BIAS"
mode.
MODE
2
Adjust the bias level.
REC LEVEL/BAL.
/BIAS
∞ ∞
MIN/L MAX/R
The high f requency The high f requency
decreases. increases.
MPX FILTER
How to record (CT-203/KXF-W 4010; Deck B only)
÷ Recording w ill start.
÷ The deck enters the stop mode automatically w hen the tape has
been recorded till the end.
Each press of the M ODE key changes the setting.
1 "LEVEL" lights up: Recording level setting mode
2 "BAL." lights up: Recording balance setting mode
3 "BIAS" lights up: Recording bias setting mode (Deck B of the
CT-2050/ KXF-W6010 only)
4 "LEVEL","BAL.",and "BIAS"go off: Counter display mode
÷ To adjust the bias level, play back the recorded sound and adjust to the
suitable level.Repeat if necessary.
÷ The bias can be adjusted to a value of ±3.
Depending on the tuner, a recorded FM broadcast may
produce a "beat" sound. In this case, press the M PX FILTER
key before recording. To cancel, press the M PX FILTER key
again.
CT-2 0 5 0 / 2 0 3 / KXF-W 6 0 1 0 / W 4 0 1 0 (En/ M )
lights up
lights up
17