Analog Input Pin Connection - NEC 78K0 User Manual

(4) Noise countermeasures
To maintain the 10-bit resolution, attention must be paid to noise input to the AV
Because the effect increases in proportion to the output impedance of the analog input source, it is recommended
that a capacitor be connected externally, as shown in Figure 13-19, to reduce noise.
Reference
voltage
input
C = 100 to 1,000 pF
(5) ANI0/P20 to ANI7/P27
<1> The analog input pins (ANI0 to ANI7) are also used as input port pins (P20 to P27).
When A/D conversion is performed with any of ANI0 to ANI7 selected, do not access port 2 while
conversion is in progress; otherwise the conversion resolution may be degraded.
<2> If a digital pulse is applied to the pins adjacent to the pins currently used for A/D conversion, the expected
value of the A/D conversion may not be obtained due to coupling noise. Therefore, do not apply a pulse to
the pins adjacent to the pin undergoing A/D conversion.
(6) Input impedance of ANI0 to ANI7 pins
In this A/D converter, the internal sampling capacitor is charged and sampling is performed for approx. one sixth
of the conversion time.
Since only the leakage current flows other than during sampling and the current for charging the capacitor also
flows during sampling, the input impedance fluctuates and has no meaning.
To perform sufficient sampling, however, it is recommended to make the output impedance of the analog input
source 10 kΩ or lower, or attach a capacitor of around 100 pF to the ANI0 to ANI7 pins (see Figure 13-19).
(7) AV pin input impedance
REF
A series resistor string of several tens of 10 kΩ is connected between the AV
Therefore, if the output impedance of the reference voltage source is high, this will result in a series connection to
the series resistor string between the AV
CHAPTER 13 A/D CONVERTER
Figure 13-19. Analog Input Pin Connection
If there is a possibility that noise equal to or higher than AV
equal to or lower than AV
small V
F
AV
REF
ANI0 to ANI7
AV
SS
V
SS
*
and AV pins, resulting in a large reference voltage error.
REF SS
User's Manual U15947EJ2V0UD
REF
may enter, clamp with a diode with a
SS
value (0.3 V or lower).
and AV
REF
pin and pins ANI0 to ANI7.
or
REF
pins.
SS
295