Table of Contents
Advertisement
Professional Quality Lawn Care Equipment
since 1945
Thank you for buying a YAZOO/KEES ZT Max! Before operating your new mower, read,
understand and follow the important safety instructions and the other instructions con-
tained in this manual. Lawnmowers and all power equipment, can be potentially danger-
ous if used improperly. SAFETY REQUIRES GOOD JUDGEMENT, CAREFUL USE IN
ACCORDANCE WITH INSTRUCTIONS AND COMMON SENSE.
Operator's Manual for
MODELS: ZKH52222
ZKH52223
ZKH52252
ZKH52253
ZKH61252
ZKH61253
ZKHP52233
ZKHP52253
ZKHP61253
ZKW52233
ZKW61233
MANUAL 103413 REV.06 (10/10/00)
Advertisement
Table of Contents
Related Manuals for Yazoo/Kees ZKH52222, ZKH52223, ZKH52252, ZKH52253, ZKH61252, ZKH61253, ZKHP52233, ZKHP52253, ZKHP61253, ZKW52233, ZKW61233
Summary of Contents for Yazoo/Kees ZKH52222, ZKH52223, ZKH52252, ZKH52253, ZKH61252, ZKH61253, ZKHP52233, ZKHP52253, ZKHP61253, ZKW52233, ZKW61233
- Page 1 Professional Quality Lawn Care Equipment since 1945 Thank you for buying a YAZOO/KEES ZT Max! Before operating your new mower, read, understand and follow the important safety instructions and the other instructions con- tained in this manual. Lawnmowers and all power equipment, can be potentially danger- ous if used improperly.
- Page 2 Congratulations on the purchase of your Yazoo/Kees mower. This manual has been pre- pared for the owners and operators of the ZT MAX™ 52" and 61" commercial mowers. Read, understand and follow the saftey and operating instructions. Failure to follow cautious operating practices can result in serious injury to the operator or other persons.
-
Page 3: Table Of Contents
SAFETY: 1. Training 2. Preparation 3. Operation 4. Transportation 5. Maintenance SETUP AND ADJUSTMENTS: 1. Park brake 2. Cutting height 3. Mower deck leveling 4. Mule drive belt tension 5.Throttle lever tension 6. Reverse spring detent adjustment 7. Motion control linkage adjustment OPERATING INSTRUCTIONS: 1. -
Page 4: Training
SAFETY TRAINING: 1. Read this manual carefully and question your dealer if something is not clear. 2. Be thoroughly familiar with the controls and proper use of the equipment. 3. Never allow children, teenagers, or people unfamiliar with these instructions to use the mower. -
Page 5: Maintenance
5. Have your mower inspected and serviced each year by an authorized Yazoo/Kees dealer. 6. Use only authentic Yazoo/Kees replacement parts to insure the safety and quality of your mower is maintained. 7. Safety decals should be replaced if they are missing or illegible. Decals can be purchased from your Yazoo/Kees dealer. -
Page 6: Equipment Setup And Adjustments
EQUIPMENT SETUP AND ADJUSTMENTS 1. Uncrate mower 2. Mount drive wheels using the four lug nuts installed on the hub. 3. Check tire pressure in all four tires. Pressure for all four tires is 15 psi 4. Remove the motion control levers and install on the outside of the control arms (See figure 1). -
Page 7: Park Brake
ADJUSTMENTS PARK BRAKE: 1. Stop engine and remove key. Release park brake and measure the length of the spring. The distance between the washers on each end of the spring should be 2-7/8" (See Fig 2 ). 2. If adjustment is needed, loosen the nut below the spring. Then rotate nut to desired position so the proper distance between the washers is obtained. -
Page 8: Mule Drive Belt Tension
MULE DRIVE BELT TENSION: 1. Stop engine and remove the key. 2. Check to make sure the bolt head in the spring loaded idler pulley, on the left side of the engine deck is positioned between the two alignment holes in the left support plate (See Fig 4). - Page 9 5. If adjustment is necessary, loosen the nut against the yoke. Apply slight rearward pres- sure to the motion control lever and turn the head of the adjustment bolt in the proper direc- tion until the lever is centered in the neutral slot. NOTE: if properly adjusted the motion control levers will return to neutral from the reverse position and reverse motion will stop if levers are released.
-
Page 10: Motion Control Linkage Adjustment
ADJUSTMENTS MOTION CONTROL LINKAGE ADJUSTMENT: 1. This adjustment must be made with the drive wheels rotating. Raise rear of the unit and block it up so the wheels are free to rotate. CAUTION: Keep hands, feet and clothing away from rotating tires. 2. - Page 11 OPERATING INSTRUCTIONS NOTE: To begin motion the operator must be in the seat and the brake disengaged before the levers can be moved from the neutral slots or the engine will kill. By moving the levers an equal amount forward or back the mower will move in a straight line in that direction.
-
Page 12: Starting And Operation
STARTING AND OPERATION: 1. Operator must be sitting in the seat. Engage park brake, blades off and place the motion control levers in the neutral slots. (See figure 6) 2. Adjust throttle to 1/2 and set choke (if needed) turn key and release as soon as engine starts. -
Page 13: Pump Drive Belt Compartment
1. Engine oil level: Check daily with engine cold and on a flat surface. Remove the dipstick and wipe clean. Reinsert the dipstick all the way. Remove the dipstick and check oil level. If oil level is low remove oil fill cap and add oil. Use engine manufacturers specs for type of oil. 2. -
Page 14: Hydraulic Filter And Oil
Then replace with new filter. Use only Yazoo/Kees p/n 102606, filter which has a bypass valve it and the correct micron filter. Loosen hose from fitting under hydraulic tank and allow tank to drain, reinstall hose to fitting. Fill tank with 20w - 50 motor oil to 1/4”... -
Page 15: Specifications
Engine: . . . (Ref. see Kohler Manual) Power (@3600 rpm): CH22 ..16.4 kW (22hp) CH25 ..18.6 kW (25hp) Peak Torque: CH22 ..45 N*m (33 ft.lbs.) CH25 . -
Page 16: Troubleshooting
PROBLEM Engine won’t start Mower will not move or moves slowly or hard Blades won’t engage Uneven cut Cut is ragged Mower moves when in neutral position Mower pulls left or right When a problem occurs, do not overlook the simple causes. For example, no fuel or battery disconnected when the engine will not start. -
Page 17: Wiring Diagram
WIRING DIAGRAM... -
Page 18: Service Record
SERVICE RECORD DESCRIPTION OF WORK DONE DATE SERVICE DONE BY... - Page 19 Peerless model 700 transmissions (first ninety days warranted by Peerless, remainder by Yazoo/Kees). In the event that any Yazoo/Kees Product warranted hereunder shall be defective or fail to conform with this limited warranty, Yazoo/Kees shall, subject to the provisions hereof, pay for, or provide labor and materials for, the repair or replacement of such defective Yazoo/ Kees Product.
- Page 20 AGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. This warranty is not subject to change or modification by anyone, including Yazoo/Kees dealers or distributors, and no Yazoo/Kees dealer or distributor is authorized to make any representations on behalf of Yazoo/Kees Power Equipment.
Need help?
Do you have a question about the ZKH52222, ZKH52223, ZKH52252, ZKH52253, ZKH61252, ZKH61253, ZKHP52233, ZKHP52253, ZKHP61253, ZKW52233, ZKW61233 and is the answer not in the manual?
Questions and answers
How do you release drives so you can pus the mower manually zkh52252
To push the Yazoo/Kees mower model ZKH52252 manually, release the drives by pulling the release as soon as the engine starts.
This answer is automatically generated
i cant fiind the belt diagram anywhere for yazoo kees 61'' commercial zt max