Table of Contents
Advertisement
Table of Contents
Using the Compactor
Read the entire manual before putting the compactor into service. If questions remain after you finish
reading the manual, contact
Improper operation could result in serious personal injuries.
• DO NOT compact contents inside a drum that is damaged. E.g. severely rusted or corroded
• ALWAYS inspect the compactor and the drum BEFORE each use. Follow the
procedures provided on p. 8. Only use the compactor if it is in
• The drum might be too heavy for 1 person to maneuver. Ask someone to help you.
• NEVER modify the compactor in any way without express, written approval from Vestil.
modifications automatically void the
• Keep fingers and hands away from the drum rim and the compactor platen while it is moving.
• DO NOT stand directly in line with the handle. DO NOT lean over the handle while operating the jack. The
handle could recoil upwards out of your hands if the handle is not pressed all the way down during each stroke.
Step A: Free the jack handle by removing the storage pin (14). See
on p. 5. Turn the jack direction levers to UP position
FIG. 7
and fully raise the compactor plate. Refer to FIG. 9
MTC-RB units: Remove the pins securing the roll-out tray to
the frame. See
FIG. 8
Step B: Center the drum under the platen.
MTC-RB units: Roll out tray. Place drum on tray and push
the tray under jack. Center drum under the platen.
Step C: Turn the jack direction levers to the DOWN position.
Step D: Stand to one side of the jack handle. Lower the compactor
platen by moving the handle up and down. Fully raise and fully lower the handle. This is necessary for
the ratchet mechanisms of the jack to properly interact.
Step E: Lower the compactor platen into contact with the waste material. Continue ratcheting the jack until the
desired degree of compaction is achieved. NOTE: To achieve optimum compression, compact waste
materials frequently. Materials will not compact as completely or easily if the drum is full or mostly full.
Step F: Once compaction is adequate, turn both direction levers to the UP position.
Step G: Raise the compactor platen high enough to remove the drum or until the platen is fully raised.
Step H: Put the jack handle in the storage position and secure it with the clevis pin (11) and hitch pin (12). See
FIG. 7
on p. 5.
Step I: Remove the drum. MTC-RB model: Pull the drum out from under the platen. Remove the drum. Push the
tray back onto the base plate. Be certain to reinstall the clevis pins and hitch pins. See
Step J: Store the compactor in a dry, indoor location. Keep the device dry at all times.
Labeling Diagram
The unit should be labeled as shown in the diagram.
However, label appearance, content, and location are
subject to change so your product might not be labeled
exactly as shown. Replace all labels that are damaged,
missing, or not easily readable (e.g. faded). Order
replacement labels by contacting
online at http://www.vestilmfg.com/parts_info.htm.
Alternatively, you may request replacement parts and
service by calling (260) 665-7586 and asking the
operator to connect you to the Technical Service
Department.
Table of Contents
Rev. 4/5/2019
Technical Service
for answers.
Limited Warranty
on p. 5.
Technical Service
Copyright 2019 Vestil Manufacturing Co.
Original
Condition.
and might make the compactor unsafe to use.
FIG. 9: Direction Selection Levers
A: Data label (Model, Serial #,
Capacity, Date)
A
B
B: Label 208 (both jack plates; on
top of platen; on jack handle)
MTC MANUAL
Maintenance & Inspections
Unapproved
DOWN
UP
FIG. 8
on p. 5.
Page 7 of 9
Advertisement
Table of Contents
