Raising the TCD Block
4
2 In the same manner, remove two screws along the lower edge
of the right side (electronics) panel. Slide the panel slightly to
the rear and lift it off.
3 Remove the back panel by removing two screws at its bottom
edge, loosening two screws at its top edge, and the lifting off
the two top screws.
4 Finally, remove the rear top cover by removing four screws,
two at each end.
1 Cap the detector base (column/makeup gas adapter
connection).
2 Remove the detector thermal cover by removing two screws,
one from each side of the cover.
Installation Guide: TCD-to-FID Series Connection