Husqvarna 525HE3 Workshop Manual page 36

4. Release the throttle trigger and make sure that it is
locked in the start throttle position.
5. Start the product.
6. If the cutting attachment starts to rotate when the
throttle trigger is in start throttle position, turn the
adjuster screw (D) counterclockwise. Turn the
adjuster screw until the cutting attachment stops to
rotate.
7. Slowly turn the adjuster screw clockwise. When the
cutting attachment starts to rotate, turn the adjuster
screw ½ turn counterclockwise.
6.15.3 To remove and install the stop switch
1. Use a flat screwdriver to loosen the stop switch.
2. Disconnect the 2 cables.
3. Remove the stop switch.
4. Install in the opposite sequence.
36 - Repair instructions
6.15.4 To disassemble and assemble the throttle
handle
1. Remove the 5 screws and carefully remove the right
handle half from the left handle half.
2. Make a note of how the inner parts of the throttle
handle are attached.
3. Remove the recoil spring (A).
D
4. Carefully use your fingers to bend open the throttle
lever (B). Remove the throttle lever, the throttle
trigger (C) and the throttle cable (D).
5. Remove the throttle trigger lockout (E).
6. Disconnect the throttle cable from the throttle trigger.
E
B
A
C
1371 - 001 - 02.07.2020