Others - Yamakawa DVD-MP12i User Manual

Others

In case of difficulty
If operation freezes, the screen goes black or the unit should otherwise not function properly,
try turning the power off then back on. Alternatively, try the following methods in the order
listed until the unit returns to normal playback mode.
1) Turn the car's ignition OFF and back ON again.
2) Press the RESET button on the face of the unit
This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the
rest of your system is properly connected or consult a professional mobile video installer.
Symptom
Unit does not
Fuse is blown.
operate.
Monitor's power is not turn on.
Condensation
Operation is
Remote control unit's
unstable.
battery is worn.
Remote control sensor or
transmitter is dirty.
No picture is
Monitor's mode is not
produced.
switched to the mode you
want to see.
Playback does
Disc is loaded upside-down.
not start.
Disc is dirty.
A disc not able to playback
with this unit is loaded.
Parental lock is set.
Picture is
Disc is being fast-forwarded
unclear or noisy
or fast-reversed.
Vehicle's battery power is
weak.
Monitor's fluorescent tube is
worn.
Image stops
Disc is scratched.
sometimes.
No disc
No disc is loaded.
Disc is dirty.
Not valid
Remote control operation
is not possible.
VIDEO SIGNAL
PAL( or NTSC) disc is loaded.
SYSTEM IS NOT
CORRECT
No sound Select the wrong Audio Out
Cause
Replace with a fuse of the specified capacity.
Turn on the m onitor's power
Wait a while(about 1 hour) for the condensation
to dry.
Replace the remote control unit's battery with
new one.
Clean the sensor or transmitter.
Switch to the mode you want to see.
Check the disc and load it with the labeled side
facing upward.
Clean the disc.
Check if the disc is able to be played back.
Cancel the parental lock or change the rating
level.
The picture may be slightly disturbed, but this
is normal.
Check the battery power and wiring.
The unit may malfunction if the battery power is
under 10.8 volts with a load applied.
Replace the monitor's fluorescent tube.
Replaced with a non-scratched disc.
Load a disc.
Clean the disc.
For some discs or playing modes, certain
operations are not possible. This not a
malfunction.
Change the TV TYPE of the unit(see SET UP).
According to the connection, set ANALOG for
using audio cable, set SPDIF/RAM/PCM for
using coaxial cable. See page 7,8 and 19.
24
Remedy