Speaker Impedance Setting; Turning On The Power - Yamaha RX-V2500 Owner's Manual

Speaker impedance setting

Be sure this unit is in the standby mode.
1
On the front panel, while holding down
STRAIGHT/EFFECT, press STANDBY/ON.
"SP IMP.–8ΩMIN" appears on the front panel
display.
STRAIGHT
EFFECT
S P I M P . - 8 M I N
2
Press STRAIGHT/EFFECT to select the
impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
Note
Speaker impedance setting function is located in the Advanced
menu (see page 84).
CAUTION
If you are using 6 ohm speakers, set the impedance to
6 ohms before turning on the power.
When all connections are complete, turn on the power of
this unit.
STANDBY
/ON
1
2
Note
Press STANDBY/ON again (STANDBY on the remote control)
to enter the standby mode.

Turning on the power

1
INPUT
PURE DIRECT
STANDBY
/ON
SOURCE PRESET/
/REMOTE A/B/C/D/E TUNING
DVD MD/TAPE
D–TV CD–R
SPEAKERS MULTI CH INPUT MODE
CBL/SAT TUNER
A B INPUT
VCR 1 CD
/VCR2
YP AO
REC OUT /ZONE 2 OPTIMIZER
MIC
POWER POWER
TV AV
A B
PHONO TUNER
V-AUX CBL/SAT
DTV VCR 1
+ +
Press STANDBY/ON (SYSTEM POWER on the
remote controls) to turn on the power of this
unit.
STANDBY
or
/ON
Front panel
Turn on the video monitor connected to this
unit.
CONNECTIONS
VOLUME
ZONE ON/OFF
PRESET TUNING
MAIN ZONE 2
/TUNING FM/AM MEMORY MODE
PROGRAM
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO TONE CONTROL
STRAIGHT
SILENT CINEMA S VIDEO VIDEO L AUDIO R OPTICAL
EFFECT
PHONES
VIDEO AUX
(U.S.A. model)
SYSTEM
STANDBY POWER
1
INPUT MODE SLEEP
CD MULTI CH IN
MD/TAPE CD-R
DVR/VCR2 DVD
SELECT
AMP
+
SYSTEM
POWER
Remote control
25