Related Manuals for Klipsch kmc1
Summary of Contents for Klipsch kmc1
- Page 1 Klipsch Battery Replacement Also use this procedure if a system reset is needed. AHW, Klipsch Group, Inc. Electronics Engineering Department...
- Page 2 Klipsch...
- Page 3 Tool needed -- #2 Phillips Screwdriver...
- Page 4 Remove 2 screws from bottom cover.
- Page 5 Second Screw...
- Page 6 Lift front edge of battery cover.
- Page 7 Lift off cover and set aside.
- Page 8 Battery exposed.
- Page 9 You may need to tip the unit up to help get the battery out. The foam makes a tight fit.
- Page 10 Pull the battery out to this point.
- Page 11 Here you can see the battery cable.
- Page 12 Slowly and gently use a finger to work the battery cable out. Pull gently on the battery with the other hand.
- Page 13 If you feel the cable is stuck… • The cable may be wrapped around another cable… Don’t force it; you don’t want to break a wire. • The connector may be caught on the edge of the battery cage. Gently moving the cable around can get the connector past the edge of the battery cage.
- Page 14 When you see or feel the connector emerge, stop pulling. (Indicated by screwdriver.)
- Page 15 Disconnect the battery. Use two hands to gently pull the connect apart.
- Page 16 The connector only fits one way. Do not force the connection.
- Page 17 Connect/reconnect the battery.
- Page 18 The connector and wire needs to be fed back through the battery cage.
- Page 19 Use a finger to tuck the cable inside the slot.
- Page 20 Keep tucking the cable into the slot until you get to this point.
- Page 21 Gently push the battery into the battery compartment.
- Page 22 If the cable is fully tucked, you should be able to push the battery fully into place...
- Page 23 Note the tabs on the battery cover line up with slots on the housing.
- Page 24 Insert the tabs into the slots at an angle…...
- Page 25 … then lower the battery cover into position.
- Page 26 Replace the 2 screws. Do not over tighten.
- Page 27 Second screw.
-
Page 28: You're Done
You’re done!