Operation; Control Panel - Electrolux ECN26105W User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 11
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban re-
fuse and rubbish. The insulation foam
contains flammable gases: the appli-

OPERATION

Switching on
Insert the plug into the wall socket.
The Pilot light will light up.
Turn the Temperature regulator clockwise.
Important! If the temperature inside the
appliance is too high the Alarm light will light
up.
Switching off
To turn off the appliance, turn the Tempera-
ture regulator to the OFF position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as fol-
lows:
• turn the Temperature regulator towards
to obtain the minimum coldness.
• turn the Temperature regulator towards
to obtain the maximum coldness.

CONTROL PANEL

1
1
High temperature alarm light
2
Pilot light
3
Action Freeze light
4
Action Freeze switch
and Alarm reset
2
3
4
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
A medium setting is generally the most
suitable.
However, the exact setting should be chos-
en keeping in mind that the temperature in-
side the appliance depends on:
• room temperature
• how often the lid is opened
• the quantity of food stored
• the location of the appliance.
Action Freeze function
You can activate the Action Freeze function
by pressing the Action Freeze switch.
The Action Freeze light will light up.
This function stops automatically after 52
hours.
It is possible to deactivate the function at
any time by pressing Action Freeze switch.
The Action Freeze light will switch off.
High temperature alarm
An increase in the temperature in the freez-
er (for example due to an power failure) is in-
dicated by:
• switching on of the Alarm light
• sounding of buzzer.
During the alarm phase, the buzzer can be
switched off by pressing the Alarm reset
switch.
electrolux 13
are recyclable.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents