Wall Mount Your 8800 Series Phones; Remove 8800 Series Phone From The Wall Mount - Cisco 8000 Series Installation Manual

Wall Mount Your Phone

Wall Mount Your 8800 Series Phones

The following wall mount options are available:
• Cisco IP Phone 8800 Series Wall Mount Kit: A nonlockable wall mount kit available for the Cisco IP Phone
8800 Series. This wall kit applies to Cisco IP Phone 8811, 8841, 8851, and 8861. The PID is CP-8800-WMK=.
• Cisco IP Phone 8800 Series Wall Mount Kit with Single KEM: The kit is installed on the Cisco IP Phone 8851
and 8861 with one attached Cisco IP Phone 8800 Key Expansion Module. The PID is CP-8800-BEKEM-
WMK=.
1 2 3
6
1
Mount the wall bracket in the desired location.
1
2
4
Installation Guide for Cisco IP Phone with Multiplatform Firmware
24
4 5
3
5
Components:
1. Four #8-18 x 1.25-inch Phillips-head screws
2. Four anchors
3. Two K30x8mm self-tapping screws
4. One phone bracket
5. One wall bracket
6. One 6-inch Ethernet cable
2
Plug in the handset cable, then attach the phone
bracket to the rear panel of the phone.

Wall Mount Your 8800 Series Phones