Audio Delay - Yamaha DSP-AZ1 Owner's Manual

I Setting by "msec"
I Setting by "meters"
I Setting by "feet"

14 AUDIO DELAY

Use this feature to adjust the delay time of all channel sounds, when this unit decodes DTS or Dolby Digital signals. Adjusting "AUDIO
DELAY" is especially important for matching the sounds to screen pictures.
Control range:
0 – 5.0 ms (for center), 0 – 30.0 ms (for rear center)
Initial settings: 0 ms (for center), 3.0 ms (for rear center)
Control range: 0.15 – 30.48 m (for main L/R, center, rear L/R, rear center)
Initial settings: 3.04 m (for main L/R, center, rear L/R), 2.13 m (for rear center)
Control range: 0.5 – 100 ft (for main L/R, center, rear L/R, rear center)
Initial settings: 10.0 ft (for main L/R, center, rear L/R), 7.0 ft (for rear center)
Caution
• No delay will be set if the same distance is set for the main L/R and center, or the rear L/
R and rear center with "meters" or "feet" selected.
Control range: 0 – 160 ms
Initial setting: 0 ms
Note
• This feature is effective when the Dolby Digital, DTS or PCM (with the sampling
frequency lower than 96 kHz) signal is being played. The set value can be used for either
format and applies to all channels.
SET MENU ITEMS
E-
61