Download Print this page

Yamaha DSP-AZ1 Owner's Manual: Normal Stereo Reproduction

Yamaha av amplifier owner's manual.
Hide thumbs

Advertisement

I Normal stereo reproduction
Press STEREO/EFFECT to turn off the sound effect for normal
stereo reproduction.
STEREO
EFFECT
STEREO
DTS
When "STEREO" is selected while Dolby Digital, DTS, or PCM
signals are being played, the following information will be shown
on the front panel display.
When Dolby Digital signals are played:
"Dolby D" + the number of channels (front/rear/ LFE signal)
STEREO
Dolby D 2/0/---
When DTS signals are played:
"DTS" + the number of channels (front/rear/ LFE signal)
STEREO
DTS
When PCM signals are played:
"PCM" + sampling frequency
STEREO
PCM 48kHz
When analog signals are played:
STEREO
Analog
STEREO
EFFECT
3/2/LFE
3/2/LFE
Cautions
• If you turn off the sound effect, no sound is output from the center
speaker, rear speakers, rear center speaker and front effect
speakers.
• If you turn off the sound effect while a Dolby Digital or DTS
signal is being output, the dynamic range of the signal is automati-
cally compressed and the sounds of the center and rear speaker
channels are mixed and output from the main speakers.
• The volume may be greatly reduced when you turn off the sound
effect or if you set "12 DYNAMIC RANGE" on the SET MENU
to "MIN". In this case turn on the sound effect.
I Displaying the information about the input
source
During the stereo reproduction, information about the signal being
played back can be displayed by setting PARAMETER/SET
MENU to PARAMETER and then pressing / . The three types of
information shown below are displayed as switched every time
pressed.
fs (Sampling frequency):
STEREO
fs:48kHz
"unknown" is displayed when the sampling frequency for the input
signal is not known.
rate (Bit rate):
STEREO
rate:1920kbps
"unknown" is displayed when the bit rate of the input signal is not
known.
flg (Identification flag):
STEREO
flg:ES Mtrx 6.1
"None" is displayed when the flag contained in the input signal to
be used for signal process cannot be detected.
BASIC PLAYBACK
is
E-
47

Advertisement

Table Of Contents

   Also See for Yamaha DSP-AZ1

   Related Manuals for Yamaha DSP-AZ1

Comments to this Manuals

Symbols: 0
Latest comments: