Yamaha DSP-AZ1 Owner's Manual page 45

5
5
Adjust the volume to the desired output level.
VOLUME
If desired, use BASS, TREBLE, BASS EXTENSION and
BALANCE. These controls are only effective for sound from
the main speakers.
BASS TREBLE
Cautions
• If the component connected to the VCR 1 OUT, VCR 2
OUT, VCR 3/DVR OUT, CD-R OUT and MD/TAPE OUT
jacks is turned off, the reproduced sound may be distorted or
the volume may be lowered for the characteristics of A/V
component. In this case, turn on the component.
• While PROCESSOR DIRECT is tuned on, tone controls
(BASS and TREBLE) or/and BASS EXTENSION cannot
be activated.
6
6
Select a DSP program if desired.
Use PROGRAM q/w (DSP program buttons on the remote
control) to select a DSP program. See pages 86 to 94 for details
about the DSP program.
PROGRAM
VOLUME
BALANCE
BASS
EXTENSION
L R
HALL 1 HALL 2 CHURCH JAZZ CLUB
1 2 3 4
ROCK ENTER– CONCERT CONCERT
CONCERT TAINMENT VIDEO 1 VIDEO 2
5 6 7 8
TV MOVIE MOVIE /DTS
EX/ES THEATER THEATER 1 THEATER 2 SUR.
9 10 11 12
+ +
CHP/INDEX 0 10 100
I BGV (Back Ground Video) function
The BGV (Back Ground Video) function allows you to combine a
video signal from a video source with a sound signal from an audio
source. (For example, you can listen to classical music while you
are watching a video.)
Using the remote control, select a source from the video group, then
select a source from the audio group. Use the input selector buttons
on the remote control to make your selections.
CABLE SAT
D–TV/LD VCR 1
Note
• The BGV function does not work if you select the sources using
INPUT SELECTOR on the front panel.
I To mute the sound
Press MUTE on the remote control. To resume the audio output,
press MUTE again.
Notes
• You can also cancel mute to press any operation buttons such as
VOLUME +/–.
• While the mute function is on, "MUTE ON" appears on the front
panel display.
• When this unit enters the standby mode, the mute function will be
cancelled.
I When you have finished using this unit
Press STANDBY/ON (STANDBY on the remote control) to set
this unit in the standby mode.
STANDBY
/ON
BASIC PLAYBACK
V–AUX TUNER PHONO
MD/TAPE CD–R CD
VCR 2 VCR3/DVR DVD
MUTE
STANDBY
E-
43