NATURAL SOUND AV AMPLIFIER DSP-AZ2
8 9 0
Turns on and sets this unit in the standby mode. When
you turn on this unit, you will hear a click and there will
be a 4 to 5-second delay before this unit can reproduce
In this mode, this unit consumes a small amount of
power to receive infrared-signals from the remote
Selects the input source you want to listen to or watch.
Sets the priority for the types of input signals (AUTO,
DTS, ANALOG) to receive when one component is
connected to two or more input jacks of this unit (see
page 30). Priority cannot be set when 6CH INPUT is
selected as the input source.
Remote control sensor
Receives signals from the remote control.
Front panel display
Shows information about the operational status of this
CONTROLS AND FUNCTIONS
D I G I T A L
e r t y u
Controls the output level of all audio channels.
This does not affect the REC OUT level.
Outputs audio signals for private listening with
headphones. When you connect headphones, no signals
are output to the PRE OUT/MAIN IN jacks or to the
(There is an exception depending on the "1H SP B SET"
setting on the SET MENU.)
Turns on or off the BASS EXTENSION function at each
time the button is pressed, this feature boosts the bass
frequency of the left and right main channels by +6 dB
(60 Hz) while maintaining overall tonal balance. This
boost is useful if you do not use a subwoofer.
Turns on or off the PROCESSOR DIRECT function at
each time the button is pressed. When this is on, BASS,
TREBLE, and BASS EXTENSION are bypassed,
eliminating any alteration of the original signal.