Clearing Learned Functions, Macros, Renamed Source Names, And Setup Manufacturer Codes - Yamaha DSP-AZ2 Owner's Manual

4
Press MACRO again when
the operation sequence
you want to program is
complete.
Note
• "ERROR" appears in the display when pressing buttons other
than indicated in each step, or more than one button at once.
Memory back-up
If the remote control is without batteries for more than
3 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries, set up the manufacturer code and program
any acquired functions that may have been cleared.
Clearing Learned Functions,
Macros, Renamed Source Names,
and Setup Manufacturer Codes
1
Press CLEAR by using a ballpoint pen or
similar object.
CLEAR
Note
• Complete each of the following steps in 30 seconds. Otherwise,
the learning mode will be automatically canceled. In this case,
press CLEAR again.
2
Press k / n to select the clear mode.
MACRO
The mode is shown in the display window in the
following order:
3
Press and hold CLEAR again for about 3
seconds.
"C:OK" appears in the display window.
CLEAR
Note
• "C:NG" appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4
Press CLEAR to exit from the clearing mode.
Once you have cleared a learned function or macro
for a button, the button reverts to the factory setting.
CLEAR
Note
• "ERROR" appears in the display window under the following
circumstances:
– when pressing a button other than the cursor and ENTER;
– when pressing more than one button at once; or
– when MACRO ON/OFF, 10KEY/DSP or PARAMETER/SET
MENU is switched to another position.
REMOTE CONTROL FEATURES
(L: name of a component) Clears
all learned functions for the
component area. Press the input
selector button, Å or ı to select
the component.
Clears all learned functions for
this unit control area.
Clears all learned functions.
Clears all programmed macros.
Clears all renamed source
names in the display window.
Clears all programmed functions
including setup manufacturer
codes. This returns to the
factory settings.
47