Changing The Source Name In The Display Window - Yamaha DSP-AZ2 Owner's Manual

REMOTE CONTROL FEATURES
6
Press and hold the button on the other
remote control that has the function you
want to program into this remote control
until "OK" appears in the display window.
Notes
• "NG" appears in the display window when programming has
not been done correctly. In this case, start over from step 5.
• This remote control can learn approximately 120 functions.
However depending on the signals learned, "FULL" may
appear in the display window much earlier than this number. In
this case, clear unnecessary programmed functions to make
further learning on the remote control.
7
Repeat steps 5 and 6 to program additional
functions.
y
• To learn functions in other source component control area,
press SOURCE SELECT k / n in step 4 to select other source
component.
8
Press LEARN again to exit from the learning
mode.
LEARN
Notes
• Learning may not be possible in the following cases:
– when the batteries in the remote control for this unit or other
components are weak
– when the distance between the two remote controls is too
much or too little
– when the remote control infrared windows are not facing at
the appropriate angle
– when the remote control is exposed to the direct sunlight
– when the function to be programmed is continuous or
uncommon
• "ERROR" appears in the display window when pressing
buttons other than indicated in each step, or more than one
button at once.
44
Changing the Source Name in the
Display Window
You can change the name that appears in the display
window on the remote control if you want to use the
different name from the original input selector button
names. This is useful when different component is set in
the input selector button.
1
Press an input selector button, Å or ı to
select the source component you want to
rename.
The selected component name appears in the display
window.
A
B
PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD
2
Press RE-NAME by using
a ballpoint pen or similar
object.
3
Press k / n to select a character.
Choices are A to Z, a to z, 0 to 9, space, -(hyphen),
and /(slash).
ENTER
4
Press l / h to move the cursor to the next
position.
y
• If you continuously want to rename another source component,
press ENTER and repeat steps 1, 3 and 4.
5
Press RE-NAME again to exit from the
renaming mode.
RE-NAME
Note
• "ERROR" appears in the display window when pressing
buttons other than indicated in each step, or more than one
button at once.
RE-NAME
ENTER