Download Print this page

Yamaha AX-596 Owner's Manual: Notes About The Remote Control

Yamaha stereo amplifier owner's manual.
Hide thumbs

Advertisement

NOTES ABOUT THE REMOTE CONTROL

Battery installation
Since the remote control will be used for many of this unit's
control operations, you should begin by installing the
supplied batteries.
1. Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of the
arrow.
2. Insert the batteries (AA, R6, UM-3 type) according to the
polarity markings on the inside of the battery
compartment.
3. Close the battery compartment cover.
1
3
Battery replacement
If you notice that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use AA, R6, UM-3 batteries.
● Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
● Remove the batteries if the remote control is not used for
an extended period of time.
● If batteries leak, dispose of them immediately. Avoid
touching the leaked material and contact with clothing,
etc. Clean the battery compartment thoroughly before
installing new batteries.
2
Remote control operation range
Remote control
sensor
Notes
● The area between the remote control and the main unit
must be clear of large obstacles.
● Do not expose the remote control sensor to strong
lighting, in particular, an inverter type fluorescent lamp;
otherwise, the remote control may not work properly. If
necessary, position the main unit away from direct
lighting.
Within approximately
6 m (19.7 feet)
3
E-

Advertisement

   Also See for Yamaha AX-596

   Related Manuals for Yamaha AX-596

Comments to this Manuals

Symbols: 0
Latest comments:
  • steve martell Dec 08, 2014 08:49:
    Love this amp, problem is it only works in direct mode. I cannot adjust bass, balance, treble etc... I have owned this amp for yrs and understand all functions of it. So there is some issue about these controls, do you have any suggestion​s on trouble shooting or should I just try a tech shop ? I am concerned about the cost of repair or should I just live with the direct mode ?