Placing The Speakers - Yamaha DVX-C310 Owner's Manual

■ Placing the speakers

Placing the center speaker (NX-C300)
When placing the center speaker on the top of the TV,
use the supplied fasteners to secure the speaker.
Peel off
the seal
1 Peel off the seals on one side of the fasteners and
attach them to the bottom of the center speaker.
2 Peel off the seals on the other side of the fasteners and
attach them to the top of the TV.
Notes
– Do not place the speaker on the TV if the top of the TV is
uneven or narrower than the bottom surface of the
speaker. Doing so may cause the speaker to fall. In this
case, place the speaker inside a TV rack or on a level
floor.
– Before attaching the fasteners to the TV, clean the surface
with a dry cloth. A dirty or wet surface may weaken the
adhesive force and cause the speaker to fall.
– Do not touch the bonding surfaces of the fasteners after
peeling off the seals. Doing so may weaken the adhesive
force and cause the speaker to fall.
Attaching to a wall
You can attach the speakers to a wall using
commercially available screws (Diameter: 3.5 to 4 mm
(1/8" to 5/32"), Length: 25 mm (1") or more). Each
speaker requires two screws.
Fastener
– +
1 Install two screws in the wall where you want to place
the speaker.
2 Hang the speaker on the screws using the holes in the
rear of the speaker.
Notes
– To attach a speaker to a wall using screws, the wall must
be firm. Do not attach a speaker to a wall that is made of
weak materials such as plaster or veneered woods. Doing
so may cause the speaker to fall.
– After attaching each speaker, check that the speaker is
fixed securely. YAMAHA will bear no responsibility for
any accidents caused by improper installations.
Hanging on a wall (NX-F300, NX-S300)
You can hang the speakers on a wall using a
commercially available bracket and screws (Diameter:
6 mm). Attach a bracket firmly to the rear of the
speakers using screws. Then mount a screw on the
wall where the speaker is to be hung and hook the
speaker securely onto the mounted screws.
Note
Do not use screw threads measured in inches for this
installation. Use metric screw threads only.
SPEAKER SETUP
Screws
(3.5 (1/8") to 4 (5/32")
mm dia., commercially
available)
20 mm (25/32") 5 mm
or more
(1/5")
151 mm
79 mm
(5-15/16")
(2-3/4")
– +
2
9
En