Yamaha CC-70W Owner's Manual page 28

Natural sound mini component system
Hide thumbs Also See for CC-70W:
Table of Contents

Advertisement

TAPE DECK OPERATION (for KXW-S70 Double Cassette Deck)
Receiver
1
DECK A select button
Tape Deck
2
5 6
3
DECK B select button
6 4
2
Tape A or tape B playback
1
Press the TAPE input selector button.
2
Open the DECK A or DECK B cassette compartment by
pressing the EJECT button.
3
Load the tape into the DECK A or DECK B cassette
compartment, and close the lid panel completely by
pressing the upper part of the center of the panel as
figured left.
* If you loaded two tapes into both the DECK A and B
cassette compartments, select the DECK A or B in
which the tape to be played back is loaded by pressing
the DECK A or B select button.
4
Set the Dolby NR switch to B or C if the tape has been
recorded with Dolby noise reduction, and to OFF if Dolby
NR was not used.
* For selection of the Dolby B or C position, refer to the
"Dolby B and C Type Noise Reduction" on page 28.
5
Set the reverse mode switch as desired.
The reverse mode switch can be operated before or during
playback, and changes tape playback as follows:
Side A only
Side B only
6
Press the play
play
button for side B.
To stop playback
Press the stop
button.
Note
When removing the tape, press the stop
then open the cassette compartment.
Direct operation
Even if an input source other than tape deck is selected,
pressing the play button (or the fast wind button) will start
playback (or fast winding) directly.
26
Side A
Side A
Side
Continuous
B
play
(8 times)
Side B
Continuous
Side B only
play
(8 times)
button to listen to side A, or the
button, and
Side B
Side A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cc-70sRx-s70Cdc-s90Kxw-s70Nx-s70Kx-s90

Table of Contents