Manual Eject (Emergency Disc Removal); Attaching An External Scsi Device; About External Scsi Devices - Yamaha AW4416 Operation Manual

Before you begin

Manual eject (emergency disc removal)

Manual eject allows you to remove the disc manually in the case of an emer-
gency such as a malfunction of the disc tray mechanism (usually temporary) or a
power failure. Please be aware that using this method frequently can cause the
CD-RW drive to malfunction. For the location of the eject hole and the proce-
dure, refer to the manual of your CD-RW drive.
In order to perform this operation, you will need a pin-like object 2 mm or less in
diameter, such as a straightened paper clip.

Attaching an external SCSI device

About external SCSI devices

The external SCSI devices referred to here are storage devices used to backup/
restore the internal data of the AW4416, and can be connected to the SCSI con-
nector on the rear panel of the AW4416. The following types of storage device
can be used.
• Type of drive: MO drives (128 MB, 230 MB, 540MB, 640 MB 1.3 GB), hard
disk drives, CD-RW drives
• Interface: SCSI-2
• Models known to work: consult your local Yamaha distributor or refer to the
website at the following URL.
<http://www.aw4416.com/>
• By "models known to work," we mean commercially available models that
• Please be aware that Yamaha Corporation will accept no responsibility for any
It is not possible to directly record or play back audio signals in realtime on an
external storage device connected to the SCSI connector.
10
— Operation Guide
Yamaha has obtained, connected to the AW4416, and successfully tested by
means of various operational tests. However, we cannot take into account
slight differences in performance that may occur due to the manufacturing tol-
erances of each manufacturer.
damages, neither direct nor indirect, resulting from the use of any of the above
storage devices.
Insert a pin-like object 2 mm
or less in diameter.
Eject Hall
* This diagram shows a CD-RW drive
manufactured by Yamaha Corporation.