Yamaha MG 6FX Owner's Manual page 24

Front & Rear Panels
6 C-R OUT Jacks
These are impedance-balanced phone-type output jacks. These
jacks output the mixed signal whose level is adjusted by the
C-R/PHONES control. Output is in stereo (L and R). These
jacks are typically used to connect to a monitor system.
The signal monitored by these jacks is selected by
NOTE
the Level-Meter Signal switches and the channel
PFL switches.
7 SEND Jacks
• AUX1, AUX2
These are impedance-balanced phone-type output jacks.
These jacks output the signal from AUX1 and AUX2, respec-
tively. You use these jacks, for example, to connect to an
effector or to a cue box or other such monitoring system.
• EFFECT
This is an impedance-balanced phone-type output jack that
outputs the signal from the EFFECT bus. You use this jack,
for example, to connect to an external effector.
8 RETURN L (MONO), R Jacks
These are unbalanced phone-type input jacks. The signal
received by these jacks is sent to the Stereo bus and the AUX1
and AUX2 buses. These jacks are typically used to receive a
return signal from an external effector (reverb, delay, etc.).
These jacks can also be used as an auxiliary stereo
NOTE
input. If you connect to the L(MONO) jack only, the
mixer will recognize the signal as monaural and will
propagate the identical signal on both L and R
jacks.
Connector Polarities
MIC INPUT, ST OUT
LINE INPUT (monaural channels),
GROUP OUT, ST OUT, C-R OUT,
AUX1, AUX2, EFFECT*
INSERT I/O
PHONES
RETURN,
LINE INPUT (stereo channels)
* These jacks will also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced.
MG16/6FX
24
9 REC OUT (L, R) Jacks
These are unbalanced RCA-pin-type output jacks. By connect-
ing these jacks to an external recorder, you can record the same
signal that is being output from the ST OUT jacks.
NOTE
0 2TR IN Jacks
These unbalanced RCA-pin-type input jacks are used to input a
stereo sound source. Use these jacks when you want to connect
a stereo sound sources (CD or DAT) directly to the mixer for
monitoring.
NOTE
A POWER Switch
Use this switch to set the mixer power to ON or STANDBY.
B AC ADAPTOR IN Connector
Connects to the included PA-30 power adaptor (see page 5).
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (–)
Tip: Hot (+)
Ring: Cold (–)
Sleeve: Ground
Tip: Output
Ring: Input
Sleeve: Ground
Tip: L
Ring: R
Sleeve: Ground
Tip: Hot
Sleeve: Ground
The mixer's ST Master Fader does not operate on
the signal output from these jacks. Be sure to make
appropriate level adjustments at the external
recording device.
You can adjust the signal level using the 2TR IN
control in the Master Control section.
Note that trace current continues to flow while the
switch is in the STANDBY position. If you do not plan
to use the mixer again for a long while, be sure to
unplug the adaptor from the wall outlet.
Use only the PA-30 adaptor included with this mixer.
Use of a different adaptor may result in fire or electric
shock.
INPUT OUTPUT
Ring
Sleeve
Sleeve
Tip
Tip