Connections - Yamaha MAgicstomp Guitar Effects Professor Owner's Manual

Connections

CAUTION
• In order to prevent electric shock or damage to your equipment, turn OFF
the power on the guitar amp, etc., and set the MAGICSTOMP's volume to its
minimum level before making any connections.
• Only use the supplied AC-10 adaptor to power the unit.
Using another adaptor may result in damage, overheating or fire, which
can be very dangerous.
• Make sure to use the recommended AC voltage as indicated on the power
adaptor.
• The supplied power adaptor AC-10 is designed specifically for use with the
MAGICSTOMP. Never use this adaptor with any other device.
• The MAGICSTOMP automatically switches "ON" when power is connected and supplied to the
device.
• Connect a guitar, bass or any line level instrument such as a synthesizer, etc., to the INPUT
jack. The MAGICSTOMP can also be connected to the effect loop of an amplifier, mixer, or
other similar device.
• Set the INPUT LEVEL switch to match the output level of the instrument or device that is
connected to the MAGICSTOMP. If the sound is distorted when the switch is set to the HIGH
position, change the setting to LOW. If you feel output is low when the switch is set to the LOW
position, change the setting to HIGH.
• When using patches with stereo output, we recommend connecting the MAGICSTOMP's out-
put jacks to a stereo device.
• When connecting to a monaural device, use the OUTPUT L/MONO jack.
• When connecting the power adaptor to the MAGICSTOMP's AC IN jack, you can wrap the
power adaptor cord around the cord hook as shown in the illustration below (this helps keeping
the plug from being accidentally pulled out).
CAUTION
• Don't let the cord bend sharply or kink when wrapping the cord around
the hook. An excessive bend can cut the cord or start a fire.
10
AC IN jack
Power adaptor cord
Cord hook