Formatting A Disk - Yamaha Electone EL-200 Owner's Manual

2

Formatting a Disk

Before recording, the disk must first be formatted.
1
Put the disk, label facing up, into the disk drive (floppy disk
slot).
"Fort" will appear on the LED display indicating that the
inserted disk requires to be formatted.
2
While holding down the SHIFT button, press the FORMAT
button.
This step puts the format operation on stand-by, indicated by the
dashes on the LED display and the flashing lamp above the
FORMAT button.
3
Press the FORMAT button again to begin formatting.
Formatting is engaged and the LED above the FORMAT button
stays lit.
6
The number "160" appears on the LED display and counts down
to "001" as the disk is being formatted. When formatting is
completed, operation returns to the original STOP status.
About SHIFT Button
You will find the SHIFT button (printed in green) at the top right
side of the M.D.R. section. Some buttons in the M.D.R. section have
dual functions: the first function is printed in white above each
button; the second function is printed in green below each button.
The SHIFT button is used to select the second functions by pressing
each function button while holding down the SHIFT.
30
RECORD PLAY
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL
SONG FROM TO
REPEAT SONG COPY
PAUSE STOP PLAY SONG SELECT
TEMPO
MUSIC DISK RECORDER
RECORD PLAY
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL
SONG FROM TO
REPEAT SONG COPY
PAUSE STOP PLAY SONG SELECT
TEMPO
MUSIC DISK RECORDER
RECORD PLAY
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL
SONG FROM TO
REPEAT SONG COPY
PAUSE STOP PLAY SONG SELECT
TEMPO
MUSIC DISK RECORDER
Formatting a disk erases all the data in the disk and
make it ready to record. The erased data by
formatting will be lost permanently. Check if the
disk contains your important data, or not, before
executing the operation.
CONTROL SHIFT
SONG DEL.
RECORD CUSTOM PLAY
FORMAT
CONTROL SHIFT
SONG DEL.
RECORD CUSTOM PLAY
FORMAT
CONTROL SHIFT
SONG DEL.
RECORD CUSTOM PLAY
FORMAT