Yamaha D24 Owner's Manual page 163

Duplication Procedure
The source and destination MO disks must be the same capacity, and the destination
disk must be formatted beforehand. See "Formatting MO Disks" on page 26 for more
information.
Turn off both D24s.
1
Turn on D24-B.
2
Insert the destination MO disk into D24-B.
3
Press the D24-B [UTILITY] button.
4
The UTILITY indicator lights up.
Use the D24-B JOG/DATA dial to select "DUPLICATE," and then press the
5
[ENTER] button.
Use the D24-B JOG/DATA dial to select "SLAVE," and then press the [ENTER]
6
button.
Turn on D24-A.
7
Insert the MO disk to be duplicated into D24-A.
8
Press the D24-A [UTILITY] button.
9
The UTILITY indicator lights up.
Use the D24-A JOG/DATA dial to select "DUPLICATE," and then press the
10
[ENTER] button.
Use the D24-A JOG/DATA dial to select "MASTER," and then press the [ENTER]
11
button.
"ARE YOU SURE" flashes on the display.
Press the D24-A [ENTER] button again to confirm your selection, or the [CAN-
12
CEL] button to cancel the Duplicate function.
The duplication process starts and "DUPLICATING" appears on the display.
When the duplication process is complete, "FINISHED" appears on the display.
To duplicate the disk again, insert a new disk into D24-B and repeat step 12.
Press the [UTILITY] buttons on both D24s to leave utility.
13
The UTILITY indicators go out.
Note: When you have finished using the Duplication function and want to use the D24s
for normal operation, disconnect the SCSI cable between them, otherwise, they may mal-
function.
Duplicating MO Disks
D24—Owner's Manual
163