Table of Contents
Advertisement
1. Connect to mains supply. When the unit is connected to the mains supply but is
turned off, the M indicator will blink every 2 seconds. Turn the unit ON by press-
ing the POWER button. The M button will display a solid light and the ice making
process will begin.
2. You can change the ice size during operation by pressing the SELECT button
to cycle through the 3 sizes. If the room temperature is lower than 15C, it is
recommended to select the small or medium ice size in order to avoid ice stick-
ing together.
3. The ice making cycle lasts approx. 6 to 15 minutes, depending on the size of
the ice cube selection and the ambient temperature. In a very wam room, ice-
making time may vary quite a lot.
4. While the icemaker is on, verify water level periodically. If water pump can't
inject water, the ice maker will stop automatically, and the "Add Water" indica-
tor will come on.
5. If tank needs refilling, press "Power" button, fill water up to the MAX water level
mark and press "Power" button again to turn on the unit
6. The ice maker automatically stops working when the ice basket is full and the
"Ice Full" indicator will be on.
7. Change water in the water reservoir every 24 hours to ensure a reasonable
hygiene level.
8. If unit isn't in use, drain all water left in the tank.
•
Always unplug the ice maker before cleaning
•
Drain the water from the tank using the drain plug after each use or the water
will go stale
•
Take out the ice basket and wipe the inside of the tank with a soft cloth moistened
with a mild detergent solution.
•
Dry with kitchen towel
•
Clean the outside of the ice maker with a soft cloth
•
Do not use abrasive or strong chemical cleaners
•
NEVER IMMERSE THE UNIT IN WATER OR RUN UNDER THE TAP
SIM100-1: Ice scoop
SIM100-2: Ice basket
SIM100_IM.indd 5
HOW TO USE
CLEANING
SPARES
5
14/07/2016 10:21
Advertisement
Table of Contents
