Appendices; Returning The Me-50 To Its Factory Settings (Factory Reset); Adjusting The Expression Pedal - Boss ME-50 Owner's Manual

Appendices

Returning the ME-50 to Its
Factory Settings (Factory Reset)
You can restore all of the ME-50's settings (thirty patches and
tuner reference pitch) to what they were at the time the unit
was shipped from the factory.
This is referred to as "Factory Reset."
To perform Factory Reset, carry out the following steps.
fig.0380
1,2 2
1. Turn off the power.
2. While simultaneously pressing BANK [
[WRITE], turn on the power.
"F" appears in the Display.
* To cancel Factory Reset, first turn off the power, and then turn
it on again.
3. Press [WRITE].
The MEMORY indicator flashes.
4. Press [WRITE] once more.
"F" flashes in the Display, and Factory Reset is executed.
Never turn off the power while Factory Reset is in
progress.
when Factory Reset is completed, the ME-50 returns to
Manual mode.
26
3,4
] and

Adjusting the Expression Pedal

Although the ME-50's expression pedal has been set for
optimum operation at the factory, extended use and the
operating environment can result in the pedal going out of
adjustment.
If you encounter problems such as being unable to switch the
PEDAL MODE SW on or off or fully cut off the sound with
the volume pedal, you can use the following procedure to
readjust the pedal.
When you operate the expression pedal, please be
careful not to get your fingers pinched between the
movable part and the panel.
In households with small children, an adult should
provide supervision until the child is capable of
following all the rules essential for the safe
operation of the unit.
1. While simultaneously pressing BANK [
[WRITE], turn on the power.
"P" appears in the Display, then changes to "U."
2. Press the heel of the expression pedal to the base, press
[WRITE].
"d" appears in the Display.
3. Press the toe of the expression pedal to the base, press
[WRITE].
"5" appears in the Display.
4. Adjust the PEDAL MODE SW.
Press BANK [ ] [
The smaller the value, the lighter is the depression force
needed to switch the pedal on or off.
5. Press [WRITE].
Save the settings in memory, then return to Manual
mode.
* If the TUNING indicator flashes during steps 2 and 3, press
the pedal again, then press [WRITE].
] and
] to set the value (1–9).