Clp-150: Keyboard Stand Assembly - Yamaha Clavinova CLP-170 Owner's Manual

CLP-150: Keyboard Stand
Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install
all parts in the correct direction. Please assemble in
accordance with the sequence given below.
• Assembly should be carried out by at least two per-
sons.
• Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing
assembly of each unit.
• To disassemble, reverse the assembly sequence given
below.
Have a Phillips-head (+) screwdriver ready.
Remove the following parts from the package.
Assembly Parts
6 25 mm long screws 4
6 16 mm short screws 6
4 12 mm thin screws 2
Side panel
(left)
Bundled pedal cord inside
112
CLP-170/150
1
4 20 mm tapping
screws 4 4
2
Cord holders 2
3
Main unit
Side panel
Rear panel
(right)
Pedal box
AC power cord
1.
Attach the side panels to the pedal box.
side
panel
(left)
(1) Untie and straighten out
the bundled cord
attached to the bottom of
the pedal box.
2.
Attach the rear panel.
(1) Place the bot-
tom edge of the
rear panel in the
grooves of the
legs, and then
(3) Secure the bottom of
fasten the upper
the rear panel to the
edge.
pedal box using four
4 20 mm
screws.
side
panel
(right)
(2) Use the four 6 25 mm long screws
1to attach the pedal box. First
attach one side panel, then attach
the other side panel.
(2) Secure the top of the rear panel
to the side panel brackets using
two 4 12 mm 3 thin screws.
4 tapping