B G R AX -9 Natural Sound Stereo Integrated Amplifier Préampli/ampli de puissance stéréo de la série “Natural Sound” Natural Sound Stereo-Verstärker Natural Sound Integrerad Stereo Förstärkare Amplificatore integrato stereo a Suono Naturale Amplificador integrado estéreo de Sonido Natural Natural Sound Geïntegreerde Stereo Versterker OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG...
MEDFÖLJANDE TILLBEHÖR ACCESSORI IN DOTAZIONE ACCESORIOS INCLUIDOS BIJGELEVERDE ACCESSOIRES Remote Control Transmitter Emetteur de télécommande Fernbedienung Fjärrkontroll Telecomando Transmisor del control remoto Afstandbediening YAMAHA HIFI SYSTEM REMOTE CONTROL TRANSMITTER DIR A DIR B REC/PAUSE – A/B/C/D/E PRESET DISC POWER VOLUME SLEEP After unpacking, check that the following parts are contained.
Thank you for selecting this YAMAHA stereo amplifier. 50W + 50W (8Ω) RMS Output Power, 0.03% THD, 20–20,000 Hz High Dynamic Power, Low Impedance Drive Capability PURE DIRECT Switch to Reproduce the Purest Source Sound Remote Control Capability Supplied Accessories ...2 Caution ...4...
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold.
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER Battery installation Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes Use only AA, R6, UM-3 batteries for replacement. Be sure the polarities are correct.
If you have YAMAHA components numbered as 1, 2, 3, etc. on the rear panel, connections can be made easily by making sure to connect the output (or input) terminals of each component to the same-numbered terminals of this unit.
CONNECTING SPEAKERS Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and –...
CONTROLS AND THEIR FUNCTIONS FRONT PANEL 1 2 3 45 6 NATURAL SOUND STEREO AMPLIFIER AX 9 STANDBY/ON Power indicator Lights up while the power to this unit is on. STANDBY/ON switch Press this switch to turn the power to this unit on. Press it again to turn this unit into the standby mode.
The remote control transmitter provided with this unit is designed to control all the most commonly used functions of this unit. If the CD player, tuner or tape deck connected to this unit are YAMAHA components designed for remote control compatibility, then this remote control transmitter will also control various functions of each component.
TO PLAY A SOURCE VOLUME Set to the “0” position. Turn the power on. STANDBY/ON Lights up. Select a desired input source. TAPE TUNER PHONO The indicator of the selected source lights up. When you finish using this unit Press the STANDBY/ON switch again to turn this unit into the standby mode.
TO RECORD A SOURCE TO TAPE (OR MD) Select the source to be recorded. TAPE TUNER PHONO Play the source and then turn the VOLUME control up to confirm the input source. VOLUME When you listen with headphones Connect the headphones to the PHONES jack. When listening with headphones privately, set both the SPEAKERS A and B switches to the OFF position.
Adjusting the BALANCE control Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused from speaker location or listening room conditions. BALANCE Adjusting the BASS and TREBLE controls BASS – BASS : Turn this clockwise to increase (or counter- clockwise to decrease) the low frequency response.
If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. SYMPTOM...
Minimum RMS Output Power per Channel 8 ohms, 20 Hz to 20 kHz, 0.03% THD ...50W+50W Dynamic Power per Channel (by IHF Dynamic Headroom measuring method) 8/6/4/2 ohms...78/88/100/112W DIN Standard Output Power per Channel (4 ohms, 1 kHz, 0.7% THD) [U.K.
YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...