Cvp-305: Keyboard Stand Assembly - Yamaha 301 Owner's Manual

CVP-305: Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
• Be sure to tighten up
all screws upon com-
pleting assembly of
each unit.
• To disassemble,
reverse the assembly
sequence given below.
1
Open the package, take out the pedal box, take
out the styrofoam pads, and place the main unit
on top of the pads.
Position the pads so that they will protect the headphone
jack and the connector panel located underneath the front
left corner.
Main unit
Connector panel
Phones jacks
Remove the parts shown below from the box.
Front panel
Rear panel
Pedal cord
Pedal box
Side panel
(left)
Assembly Parts
6 x 25 mm long screws x4
6 x 16 mm short screws x4
4 x 14 mm thin screws x8
2
Attach the side panels to the pedal box.
2 Remove the vinyl tie from the folded
pedal cord. Do not
remove the vinyl tie
located next to the
Side panel Side panel
hole.
(left) (left)
202 CVP-305/303/301 Owner's Manual
Have a Phillips-head (+) screw-
driver ready.
To prevent the key
cover from accidentally
opening during assem-
bly, press down on the
key cover, making sure
that the sheet (shown)
remain in place.
Styrofoam pads
Side panel
(right)
AC power cord
4 x 20 mm tapping screws x5
Cord holders x2
1 Use the four 6x25 mm
long screws to attach
the pedal box. First
attach one side panel,
Side panel Side panel
then attach the other
(right) (right)
side panel.
3
Attach the front panel.
1 Align and attach the front panel to the front side of the pedal
box and both side panels.
2 Secure the panel using the 4x14mm thin screws.
* Insert six screws into the smaller holes on the brackets.
4
Mount the main unit.
CAUTION
• Fingers can become pinched between the main unit
and the rear or side panels, be extra careful so as not to
drop the main unit.
• Do not hold the keyboard in any position other than
the position shown in the illustration.
Be sure to place your hands at least 10 cm
from either end of the main unit when posi-
tioning it.
At least At least
10 cm 10 cm
5
Fix the main unit.
1 Center the main unit to produce equal clearance on the left
and right sides.
2 Use 6x16 mm
short screws to
secure the main
unit from the rear.
* Use the front hole
on the front
brackets to attach
the screws.