Yamaha FJR1300 Owner's Manual page 65

1. Screw
2. Reservoir cap cover
3. Reservoir cap
3. If the coolant is at or below the
minimum level mark, remove
cowling A (See page 6-6 for cowl-
ing removal and installation proce-
dures.), open the reservoir cap,
add coolant to the maximum level
mark, close the reservoir cap, and
then install the cowling.
Coolant reservoir capacity:
0.25 L
PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
_
If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
_
WARNING
_
Never attempt to remove the radia-
tor cap when the engine is hot.
_
6-14
EC000080
NOTE:
_
The radiator fan is automatically
switched on or off according to the
coolant temperature in the radia-
tor.
If the engine overheats, see page
6-35 for further instructions.
_
EW000067
6