Appendix; Solutions To Common Problems; General Problems - Yamaha DVX-S200 Owner's Manual

Solutions to Common Problems

General Problems

Power turns on but immediately shuts off.
1 The power plug is not completely plugged
Cause
in.
Solution
Insert the plug into the outlet firmly.
2 Speaker cable is shorted. When power is
Cause
turned on, the protective circuit engages and
shuts the system down.
Make sure that all speaker cables are
Solution
correctly connected.
3 CinemaStation received a strong, external
Cause
electric shock such as from a lightening bolt
or excessive static electricity.
Put CinemaStation in standby, pull out the
Solution
electric cord then wait for about 30 seconds
before reinserting the cord and turning on
the power again.
4 The system cable is not connected properly.
Cause
Connect the system cable securely.
Solution
No sound.
1 You did not connect the cable properly.
Cause
Solution
Check your connections.
2 The source you selected is not suitable for
Cause
playback.
Choose the correct source using the Input
Solution
Selection buttons.
3 You did not connect the Speaker cable
Cause
properly.
Check your speaker connections.
Solution
4 You turned the sound volume down.
Cause
Solution
Turn the sound volume up.
Be sure to check the points below if CinemaStation doesn't seem to be
working normally for you. If you notice something wrong that is not listed
below and you have already tried some solutions with no success, turn off
the CinemaStation power, remove the power plug from the outlet and contact
the store where you purchased the product or your nearest YAMAHA sound
products service center and ask for assistance.
No picture.
The audio suddenly decreased.
Sound is too low on one side.
5 Sound is muted.
Cause
Press MUTE or VOLUME +/- to regain the
Solution
sound and adjust the volume to your liking.
6 You inserted a CD-ROM that CinemaStation
Cause
cannot play.
Play a source signal that CinemaStation can
Solution
play.
You did not connect the cable properly.
Cause
Check your connections.
Solution
The Sleep Time function started working.
Cause
Turn the power back on and try playing the
Solution
source again.
Cause
You did not connect the cable properly.
Check your connections.
Solution

Appendix

97