Adjusting The Speaker Output Levels - Yamaha AV-S70 Owner's Manual

ADJUSTING THE SPEAKER OUTPUT LEVELS

When reproducing a Dolby Surround source using a DSP program such as DOLBY PRO LOGIC or DOLBY DIGITAL
ENHANCED, it is necessary to adjust each channel to the same output level in order to bring out the full digital effect of
these sound fields. Even when a different DSP program is used, it is possible to bring out the particular flavor of the sound
field in question.
Speaker output levels may be adjusted by using the remote control before playback by following the steps.
1
2
1
Press p to turn on the power.
If the STANDBY indicator is lit, turn on the power
using p on the remote control. If the main power is
off (when the STANDBY indicator is not lit), turn on
the power by pressing POWER on the front speaker
unit.
2
Press TEST.
Test tones (like pink noise) will be output in the
following order.
When only the front speaker unit is being used
or the VIRTUAL SURROUND DSP program is
selected:
Front speaker unit
LEFT
LEFT
SURROUND
(Virtual)
When an NX-SW70 is connected:
Front speaker unit
LEFT CENTER
LEFT
SURROUND
Rear speakers
RIGHT
RIGHT
SURROUND
(Virtual)
RIGHT
RIGHT
SURROUND
15