(4) Click
normally." will be displayed.
(5) Click the [OK] button in the message dialog box. A HEX file for flash memory writing will be created.
5.2
Operation with SM+
This section describes examples of checking the operation on the I/O panel window or timing chart window of SM+.
For the details of how to operate SM+, refer to the
<R>
(1) When SM+ for 78K0S/Kx1+ W1.02 ("SM+" hereafter) is used in the environment of PM+ Ver. 6.30, SM+ cannot
be selected as the debugger. In this case, start SM+ via method (a) or (b) described below, while keeping PM+
running after completing building a project.
(a) When starting SM+ in PM+
<1> Select [Register Ex-tool] from the [Tool] menu and register "SM+ for 78K0S/Kx1+".
<2> Select [Ex-tool Bar] from the [View] menu and add the SM+ icon to the PM+ toolbar.
<3> Click the SM+ icon and start SM+.
(See the PM+ help for details on how to register external tools.)
(b) When not starting SM+ in PM+
•Start SM+ from the Windows start menu.
CHAPTER 5 OPERATION CHECK USING SYSTEM SIMULATOR SM+
([Build] button). When the source files are built normally, the message "I3500: Build completed
Click
A HEX file for flash memory writing will be generated.
Application Note U18752EJ2V0AN
Click
SM+ System Simulator Operation User's
Manual.
31