Dist+Wah - Yamaha VL Owner's Manual

Dist+Wah

40
VL Version 2
Use the ¡ (">") and ™ ("<") buttons to switch between the two pages
•
of effect parameters.
Dist+Flanger Effect Block Diagram
L In
R In
Element on/off — E1: & E2:
¯
In this parameter the cursor can be positioned at "E1:" or "E2:" to individually
turn the Dist+Wah effect on or off for elements 1 and 2, respectively. When "on" the
output of the corresponding element is fed to the input of the modulation stage, and when
"off" the modulation stage is bypassed. The "E2:" parameter will not appear when
editing a single-element voice.
Overdrive
¯
Sets the intensity of the overdrive or distortion effect. Higher values produce more
distortion.
Speaker
¯
Simulates a variety of speaker types and configurations via which the distortion
sound might be reproduced.
Flat
Stack
Combo
Twin
Radio
Megaphone
Wah Distortion
Pre/Post
No speaker — the sound of a "direct feed" to a recording or sound
reinforcement console.
The powerful, expansive sound of stacked speaker cabinets.
A single 12" speaker unit in an open-backed enclosure.
Two 12" speaker units in a relatively small open-backed enclosure.
The small, compressed, but pleasant tone of a radio receiver.
Constricted tone with emphasis on the middle frequencies.
L Out
Wah
R Out