Preparing The Pocket Controller - Yamaha Pro IV Series Operating Manual

CHAPTER 1: Getting Started
Preparing the Pocket
Controller
1
Remove the card slot protector, and
then insert the supplied CF wireless
LAN card into the CF card slot.
2
Set the battery replacement switch to
the [REPLACE BATTERY] position.
3
Put the rechargeable battery into the
battery compartment.
Make sure that the
the battery are aligned correctly with those
printed inside the battery compartment.
4
Set the battery replacement switch
back to the [NORMAL OPERATION]
position.
15
NORMAL OPERATION
REPLACE BATTERY
, and marks on
5
Remove the I/O port cover, and then
set the Pocket Controller on the
cradle.
Charging starts and the charge indicator lights
amber. When the battery is fully charged, the
indicator goes out.
Notes on Rechargeable Battery
The rechargeable battery used in the Pocket Controller
should last for one to two years under ordinary usage.
When in use, the battery should hold a charge for 60 to 90
minutes. If the battery loses its ability to hold a charge or
recharging cannot be completed, contact your nearest
dealer and replace the rechargeable battery.
Use the following methods to increase the life of the
rechargeable battery:
• For normal use, disconnect the Cradle from the
"EA-70" AC adaptor, and reconnect it only when
recharging.
• Turn off or dim the backlight of the Pocket Controller's
touch screen with [Light & Power] setup.
• When the Pocket Controller is not in use, hold down
for approximately two seconds to turn off the
Pocket Controller.
• When the Pocket Controller is not used for a long
period of time, remove the rechargeable battery.
I/O port cover
Charge indicator