Setting Up the PSR-2000/1000
Make sure that the PSR-2000/1000's STANDBY/ON
switch is at the STANDBY (off) position.
Connect one end of the AC cable to the PA-300.
Connect the PA-300's DC plug to the PSR-2000/
1000's DC IN terminal on the instrument's rear
DC IN 16V
Connect the other end (normal AC plug) to the
nearest electrical outlet.
Do not attempt to use an AC adaptor other than the Yamaha PA-
300 or an equivalent recommended by Yamaha. The use of an
incompatible adaptor may cause irreparable damage to the PSR-
2000/1000, and may even pose a serious shock hazard! ALWAYS
UNPLUG THE AC ADAPTOR FROM THE AC POWER OUTLET
WHEN THE PSR-2000/1000 IS NOT IN USE.
Never interrupt the power supply (e.g. unplug the AC adaptor)
during any PSR-2000/1000 record operation! Doing so can result
in a loss of data.
Even when the switch is in the "STANDBY" position, electricity
is still ﬂowing to the instrument at a minimum level. When not
using the PSR-2000/1000 for an extended period of time, be sure
to unplug the AC power adaptor from the wall AC outlet.
To electrical outlet
When you have made all the necessary connections
(page 152) between your PSR-2000/1000 and any other
devices, make sure that all volume settings are turned
down all the way to zero. Then turn on every device in
your setup in the order of MIDI masters (senders), MIDI
slaves (receivers), then the audio equipment (mixers,
ampliﬁers, speakers, etc.). This ensures smooth MIDI
operation and prevents speaker damage.
When powering down the setup, ﬁrst turn down the
volume for each audio device, then switch off each
device in the reverse order (ﬁrst audio devices, then
MIDI master (transmitting device)
PSR-2000/1000 as MIDI slave (MIDI receiving device)
Audio equipment (first mixer, then amplifier)