Advertisement
Installation Instructions:
EMG Model: PA-2
1) The PA-2 requires a 1/4 inch hole (6.2mm) and the
barrel length is 5/16 inches long (8mm). Optimum
control compartment body thickness is less than 1/4 inch.
Note: Place one flat washer over switch barrel before installation.
2) The PA-2 features EMG's 5 pin Quik-Connect system plug
for ease of installation and it allows you to exchange other
EMG Accessory Circuits in it's place. The EMG 5 pin
connector always uses the following legend for hook-up.
Wire Legend:
Red
Supply Voltage +9/+18/+27
Green
Output of PA-2
Black
Ground
Black
Ground #2 for convenience
White
Input to PA-2
3) Install the PA-2 in the guitar and then follow the diagram(s)
on this sheet that best fit your installation.
Diagram 1
PA-2
with:
Diagram 2
PA-2
with:
2 Volume (Either volume will act as master
w/ selection switch in middle position)
2 Tone
w/ Gibson Style Toggle Switch
Red wires from Pickups
Pickup Output Cable
Pickup Output Cable
Solder Pickup Braids to pot casings
Red
Volume
Volume
Solder Bridge Pickup "Hot" lead to this lug
Solder Fingerboard Pickup "Hot" lead to this lug
The diagrams shown are for EMG Active Pickups only.
All diagrams show the Red Wire coming from the pickups
connected to the battery. If you are installing EMG-HZ
Passive Pickups refer to those diagrams. The Red Wire of
the HZ Pickup is NOT for battery power, it is a coil wire.
Black
.1uf
Black
104
Tone
.1uf
104
Tone
Red
Green
Bottom View
White
Green
Red
Advertisement
